Sliding Doors Guide

June 23, 2021 in News Tags:

1. Door system is installed after the assembly of the internal filling wardrobe and installation of partitions, ceiling and floor. Ie last. 2. Necessary to the nearest millimeter tape measure to measure the width of the opening in the top of the cabinet, where it will be an upper guide. te. The top rail has a form W-shaped beams. After the removal of the size of internal opening at the top of this result we subtract 2 mm, and cut off the top guide to get the size. Must be cut precisely at right angles.

Pick up a square and draw a perimeter line that will cut it. Remember that it is better to measure seven times and once cut, rather than vice versa. Cut starting from the back side. Hacksaw at call time and again come off and scratch profile. 3. After a gap of 30-50 cm guides on site for future self-tapping screws. When working with a guide to keep her bearings, or the floor so that the profile open side looking at us, not down. This will allow us to scratch it for less visible.

Hole under the screws should be drilled parallel to the two parties, ie In each letter P. When using the hole with only one hand, the guide is usually not worth perpendicular to the door of the closet, making it difficult to slide the upper wheel. 4. Prepared by the upper guide insert in the cabinet and fasten neatly, leaving a uniform gap with the each side (if you could just cut off, then, accordingly, to 1 mm on each side). Make sure that the guide was parallel to the ceiling of the cabinet and uniformly recessed relative to the side walls of the cabinet or niche. 5. Measure the length of base cabinet and cut the lower track at 1 mm shorter. Make sure that the cuts were made at a right angle. 6. Insert the bottom rail, but do not fasten it to the floor of the cabinet. 7. Put in the place door coupe. This operation encouraged to do together partner. First, insert the door into the back of the guide. To do this, insert the first upper guide wheel at the top and then curled a finger bottom wheels to have a door inside cabinet and insert the lower wheel guide. 8. After installing the doors in the closet, you must use the adjustment screws in the lower wheel to adjust the doors on the side walls of the cabinet. 9. Pose the left door of your closet the left side of themselves deviate to the right and check the parallelism of the door side of the cabinet. If necessary, move the lower track, thereby adjusting the parallelism of the door and the sidewall of the closet. Repeat the operation on the other side of the cabinet. 10. Attach the guide screws on the floor closet. Attention! Screwed bottom of the guide should be only if you believe that more than any manipulation of the cabinet door coupe you will no longer produce. Congratulations! You did it, and became owner of a wonderful wardrobe, made their own hands! On the quality of door assembly compartment is highly dependent softness and smoothness of their progress. Good luck You in a separate manufacturing wardrobes and other furniture in your apartment. And yes you will arrive with the force.


Comments are closed.